EXFO ETS-1000G - Manual (Page 175)

Remote Control Commands
10 Gigabit Ethernet Analyzer 165
Remote control commands (TELNET). Configuration mode
ctraf header src mac
XX:XX:XX:XX:XX:XX
Set the source MAC address.
ctraf header src ip i.i.i.i Set the source IP address.
ctraf header src udp int Set the source UDP port number.
ctraf header dst mac
XX:XX:XX:XX:XX:XX
Set the destination MAC address.
ctraf header dst ip i.i.i.i Set the destination IP address.
ctraf header dst udp int Set the destination UDP port number.
ctraf header vlan count off / 1 / 2 / 3 Select the number of VLAN tags.
ctraf header vlan [1-3] id int Set the VLAN identifier value.
ctraf header vlan [1-3] priority int Set the traffic priority value.
ctraf header precedence int Set the frame priority value.
ctraf header tos text Set the Type of Service of a packet.
ctraf rate int Set the data rate value (in percentage terms by
default).
ctraf rate int unit Specify the data rate value, including the unit
(Kbps, Mbps or %).
ctraf frame int Specify the frame size.
BERT
bert header mpls tx count off / 1 / 2 / 3 Select the number of labels to be transmitted.
bert header mpls tx [1-3] label long
Set the label value.
bert header mpls tx [1-3] cos int Set the Class of Service of a packet.
bert header mpls tx [1-3] ttl int Set the time-to-live of a labeled packet.
bert header autoarp off / on Disable/enable the feature of submitting an
ARP request automatically.
Command Action