EXFO ETS-1000G - Manual (Page 163)

Remote Control Commands
10 Gigabit Ethernet Analyzer 153
Remote control commands (a console terminal)
show rfc2544 frames [1-9] size The frame size defined by a user (or a
standard value that complies with RFC 2544).
show rfc2544 frames [1-9] enable Display whether the frame size is to be used
for performing the test.
show rfc2544 latency enabled Display whether the frame propagation delay
analysis is to be made.
show rfc2544 latency count The number of test iterations for the latency
analysis.
show rfc2544 latency duration The test duration for the frame propagation
delay analysis, s.
show rfc2544 latency rates src The source of load values for the latency
analysis.
show rfc2544 latency rates [1-9] The load values to be used for the latency
analysis.
show rfc2544 frameloss enabled Display whether the frame loss rate analysis is
to be made.
show rfc2544 frameloss duration The test duration for the frame loss rate
analysis, s.
show rfc2544 frameloss steps The number of load adjustment steps for the
frame loss rate analysis.
show rfc2544 frameloss rates start The initial load value for the frame loss rate
analysis, specified in %
show rfc2544 frameloss rates stop The final load value for the frame loss rate
analysis, specified in %
show rfc2544 back2back enabled Display whether the limit load analysis is to
be made.
show rfc2544 back2back count The number of test iterations for the limit load
analysis.
show rfc2544 back2back duration The test duration for the limit load analysis, s
Command Information to be output to the console