EXFO ETS-1000G - Manual (Page 174)

Remote Control Commands
164 ETS-1000G
Remote control commands (TELNET). Configuration mode
rfc2544 frameloss rates stop Set the final load for the frame loss rate
analysis, specified in %.
rfc2544 back2back enabled no / yes Disable/enable the limit load analysis.
rfc2544 back2back count int Set the number of test iterations for the limit
load analysis.
rfc2544 back2back duration int Set the test duration for the limit load analysis
rfc2544 back2back rates src throughput
/ manually
Set the source of load values (throughput,
manually).
rfc2544 back2back rates [1-9] Set the load values for each frame size.
rfc2544 advanced wait int Set the Interval parameter value.
rfc2544 advanced learn int Set the Learning parameter value.
Complex traffic
ctraf header mpls count o / 1 / 2 / 3 Select the number of labels.
ctraf header mpls [1-3] label long Set the label value.
ctraf header mpls [1-3] cos int Set the Class of Service of a packet.
ctraf header mpls [1-3] ttl int Set the time-to-live of a labeled packet.
ctraf header autoarp off / on Disable/enable the feature of submitting an
ARP request automatically.
ctraf header diffserv prec+tos / dscp Select the IP Precedence field and the Type of
Service field or the DSCP field for inserting.
ctraf header dscp text Set the value of the DSCP field, 8 bits.
ctraf nstreams int Specify the number of data streams.
ctraf stream int Specify the number of the stream to be
adjusted.
ctraf duration int Set the duration of generating the specified
quantity of streams.
Command Action