Remote control over telnet – EXFO ETS-1000G User Manual
Page 133
Remote Control
10 Gigabit Ethernet Analyzer
123
Remote Control Over TELNET
Data bits: 8
Parity: No
Stop bits: 1
Flow control: No
7. Click OK and HyperTerminal will attempt to establish a connection to
the device. Check the connection using the AT command.The device
should respond OK.
Remote Control Over TELNET
TELNET (Telecommunication Network) is a protocol for accessing a
remote network device. This protocol enables a PC user to communicate
with the device which is located on the far end of the connection to
configure test parameters, to view existing settings and to conduct tests.
It is possible to interact with the device using HyperTerminal, an
application that is included in the standard delivery set of OS Windows, as
well as third-party terminal programs that enable file transfer over TELNET.
To control ETS-1000G over TELNET, take the following actions.
1. Connect the device to a PC through test or the LAN port.
2. Set up a network connection (refer to Network Parameters on
3. Enter the following command in the terminal application:
telnet port IP address
4. The username and the password (by default) are admin.
5. The interaction with the device is implemented using the commands