EXFO ETS-1000G - Manual (Page 167)

Remote Control Commands
10 Gigabit Ethernet Analyzer 157
Remote control commands (a console terminal)
show bert rate The stated load, Kbps
show bert duration The measurement duration.
bert start Start the BERT test.
bert stop Stop the BERT test.
bert results Results of the BERT test.
Packet jitter
jitter start Display whether the test traffic generator is
enabled or disabled.
show jitter txgen The threshold jitter value, ms.
show jitter threshold The jitter measurement duration.
show jitter duration Start the Packet Jitter test.
jitter stop Stop the Packet Jitter test.
jitter results Results of the Packet Jitter test.
Test traffic
show txgen header src mac The source MAC address.
show txgen header src ip The source IP address.
show txgen header src udp The source UDP port number.
show txgen header dst mac The destination MAC address.
show txgen header dst ip The destination IP address.
show txgen header dst udp The destination UDP port number.
Command Information to be output to the console