EXFO ETS-1000G - Manual (Page 170)

Remote Control Commands
160 ETS-1000G
Remote control commands (a console terminal)
show ifce mpls tx rule Display whether the rule for sending packets
to the subnet is enabled or disabled.
show ifce mpls tx subnet The subnet IP address.
show ifce mpls tx mask The subnet mask.
show ifce mpls tx stack count The number of labels to be added to the
packet to be transmitted.
show ifce mpls tx stack [1-3] label The label value.
show ifce mpls tx stack [1-3] cos The Class of Service of a labeled packet.
show ifce mpls tx stack [1-3] ttl The time-to-live of a labeled packet.
show ifce mpls rx count The number of labels in incoming packets.
show ifce mpls rx [1-3] label The label value.
Interface parameters. LAN port
show lan mac The MAC address of the LAN port.
show lan vlan count The number of VLAN tags.
show lan vlan [1-3] id The VLAN identifier value.
show lan vlan [1-3] priority The traffic priority value.
TCP/IP tests
ping Start the Ping test.
Saving/loading results
results save N Save measurement results and assign them
serial number N (N = 1...10).
results load N Load the saved measurement results which
were assigned serial number N.
results show Display the current measurement results.
results show N Display the saved measurement results
which were assigned serial number N.
Command Information to be output to the console