EXFO ETS-1000G - Manual (Page 131)

10 Gigabit Ethernet Analyzer 121
23 Remote Control
ETS-1000G provides an opportunity of communicating with a personal
computer through the USB 1.1/2.0 interface or the LAN port. Thus a user
can control the device in the terminal mode over TELNET, through the
WWW interface, and conduct tests, adjust analysis parameters, obtain
measurement results and update software versions.
Updating SW versions on the device
Note: Inappropriate actions during the SW update operations may cause partial
inoperability of the device. In this case the recovery can only be
implemented at the service center.
The most recent SW versions for ETS-1000G are available in the Internet
(http://www.myexfo.com). The current software version numbers can be
viewed in the Information menu (Device Settings > Information).
To update the device's software, follow the procedure below:
1. Download the file system image file and save it on the PC.
2. Connect the device to the external power supply.
3. Establish a connection to the PC via USB (refer Connecting to a PC via
the USB Interface on page 122).
4. Check the connection using the AT command. The device should
respond OK.
5. Open the loader menu. To do so, press and hold the
power-on/power-off button, and simultaneously press the reset button,
which is located on the side panel of the device.
6. The following message should be displayed in the program's window:
ETS-10G+ bootloader 0.0.15
Update via XMODEM:
CCCC...
7. In the Transfer > Send File menu of HyperTerminal specify the path to
file system image file in the Filename window.