Removing and replacing the bobbin case – SINGER 5430 User Manual
Page 96
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
S I N G E R
■
Removing and
replacing the
bobbin case
To remove bobbin case
1.
Remove needle plate.
2.
With a small screwdriver, turn bobbin case holdertothe rear
as far as it will go (i Illustration 1).
3.
Lift the left side of the bobbin case and slide it out to the left
and outfrom the machine, (illustration 2).
Replacing the bobbin case
1.
Guide rimAofbobbin case underfeed (C).
2.
Draw rim
B
of bobbin case under position plate
(D).
Be sure
bobbin case is freely seated on hook race.
3.
Turn bobbin case holder forward (illustration 3) as far as it
will go, locking bobbin case in place.
4.
Replace needle plate. Tighten screws with the accessory
screwdriver.
5.
Insert bobbin and close the bobbin visor.