SINGER 5430 - Manual (Page 40)

S I N G E R
Inserting a bobbin
DO NOT FORGET TO SWITCH OFF THE MACHINE
WHILE WORKING IN THE BOBBIN AREA.
1. Liftpresserfoot.
2. Turn hand wheel toward your direction until needle is in its
highest position.
3. Pull approximately 1 0 cm of thread from replacement
bobbin and insert bobbin into case (illustration 1).
Note: While unwinding, the bobbin shall turn from right to
left.
4. Holding bobbin in place, guide thread into slot A
(illustration!).
5. Guidethe line down the slottothe left around until guiding
slot B (illustration!).
6. Close the bobbin visor partially allowing some thread
(illustration 4).
^
r
y V