SINGER 5430 User Manual
Page 38
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
S I N G E R
8.
Holding
up
thread
end
upwards
(illustration
6),
step
on
foot speed control pedal to run machine.
9,
After
a
couple
of
turns,
stop
the
machine
and
trim
thread
end
near
the
hole.
Continue
to
wind
the
bobbin
until
thread
end.
The
bobbin
will
automatically
stop
when
it
is
full.
10.
Trimthethreadend, pushthebobbintotheleftand remove
the pin (illustration?).
11.
Press the bobbin winding indent to its original position. If
necessary, turn the hand wheel until it locks (illustrations).
36
This manual is related to the following products: