Maytag Atlantis - Manual (Page 95)

Tub Full Of Water
• Check for drain hose restriction.
• Check for drain plumbing restriction.
• Check pump for obstruction or proper
operation (Page 5-5).
• Check pump pulley (Page 5-5).
• Check for proper polarity of motor against
timer sequence chart (Page 8-3).
• Check for loose or slipping belt.
• Check reference marks on drive pulley and
cams (Page 7-6).
Check lid switch assembly (Page 8-79).
Check timer harness connector for proper
wiring (Page 8-3).
Check water level switch (during agitation)
(Page 8-16).
Check wiring of option selector switches
No Rinse Fill
• Check to see if washer will fill with warm
and cold water in WASH cycle.
• If washer will not fill in wash cycle, refer
to the "Will Not Fill" section.
No Timer Advance
• Check for proper wash cycle selected.
NOTE: Soak sequence during Delicate Cycle
(Page 8-3).
• Check for proper voltage at timer motor.
• If voltage is good, check timer motor for
correct ohm reading (Page 1-8).
• If no voltage, check voltage at outlet
(Page 1-2).
• Check timer (Page 8-3) or microprocessor
АТС (if so equipped) connections (Page 8-
6 ).
• The analog АТС only regulates the WASH
fill, it affects the Warm - Warm and does
not affect the RINSE water fill.
• The microprocessor АТС regulates all wa­
ter flow in the machine.
• Check water temperature selector switch
for continuity in rinse cycle (Page 8-18).
16009485-01
©1999 Maytag Appliances Sales Company
Section 9. Troubleshooting
9-5