Disassembly and testing, Centrifugal switch, Overload – Maytag Atlantis User Manual

Page 116: Water valves, Cold, Main winding, Start winding

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Section 1. Product Definition;

The Atlantis III is similar to previous Atlantis washer models, with the following exceptions:

•

The Control Wire Harness has a connector

• A new non-serviceable water pump,

which allows removal of the entire Console
Assembly from the cabinet.

•

Automatic Temperature Control. The incoming

water temperature is controlled by 2 thermostats

attached to the Injector Assembly.

Section 2. Console

Disassembly and Testing

The Console Assembly has been designed to allow full

removal of the console from the cabinet via a plug
added to the wiring harness. This feature will also aid

in performing diagnostic tests to the various

Centrifugal Switch

Attach Ohm Meter leads to BK 32 and OR 31 .5 ohms.

Overload

Attach Ohm Meter leads to WH 9 and YL M .5 ohms.

Water Valves

Hot

Attach Ohm Meter leads to OR 13 and BR151 ohm.

Cold

Atteich Ohm Meter leads to BU 11 and BR 1 ohm.

Main Winding

Attach Ohm Meter leads to WH 9 and BK 32 2 ohms.

Start Winding

16009485-03 Rev. 0