Maytag Atlantis User Manual

Page 62

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

BRAKE REPLACEMENT

SNUBBER REPLACEMENT

Apply silicone grease (part number

203959) to the splines of the drive tube and

rotor, if needed.

NOTE: This is a dry operating brake assem

bly. Make sure no oH or grease comes in con
tact with the mating surfaces of the brake lin
ing and/or brake stator. Clean both surfaces

with an alcohol saturated doth before

assembly.

2. Compress the brake spring until the stator

and snubber fit firmly against the suspen
sion housing before affixing the mounting
screws.

3. Follow the drive pulley and cam reassem

bly as detailed previously.

1. Remove belt.

2. Lift top cover and remove front panel.

3. Remove tub to pump hose and air bell

hose.

4. Remove six suspension springs.

5. Lift complete tub and drive assembly out

of cabinet, then carefully place onto floor.

Be careful not to damage the air bell nipple
on the outer tub.

6. Remove pulley and brake assembly.

7. Remove snubber.

8. To reassemble; reverse above steps.

16009485-01

Section 7. Transmission And Related Components

7-8