Maytag Atlantis - Manual (Page 43)

TUB TOP
The tub top is constructed of molded polypro­
pylene. It is secured to the tub by eight (8)
tabs which have been formed around its up­
per edge. These tabs snap over mating tab
locks which are molded around the upper
sides of the tub.
Overflow
Area
Figure 5-3
Designed into the tub top is a drain groove,
an overflow area, and a bleach dispenser. In
case water should splash out of the basket
during machine operation, the drain groove
directs the water back into the tub. The over-
fiow area is located at the tub top rear and
will direct any overflow water away from the
drive motor. The bleach dispenser is func­
tional only when used in conjunction with the
proper cabinet top assembly which is avail­
able on designated models.
A foam seal has been installed in a groove on
the underside of the tub top. The seal pro­
vides a water seal between the tub and the
tub top.
It is necessary to remove the tub top before
removing the inner tub. To remove the tub
top, push down on it while disengaging the
tabs from the tab locks on the tub.
NOTE: When reinstalling the tub top, please
observe the following:
1. Make sure the foam seal is in place
on the underside of the tub top.
2. Align the tab (Position 7:30- looking down
on the tub top) having the larger opening
with its mating tab lock on the tub, and
lock it down around the tub. This seals
the top.
AGITATOR
The agitator is composed of an auger and a
base. The base is a four-vane design molded
from a polypropylene compound. It is tough
flexible material, highly resistant to breakage.
The agitator is mounted on the splined shaft
and secured with the agitator retaining screw
and washer. A fabric softener dispenser snaps
over the top of the agitator (Figure 5-5).
16009485-01 Section 5. Water Related Components 5-3
©1999 Maytag Appliances Sales Company