Maytag Atlantis User Manual

Page 45

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Figure 5-7

REMOVAL

1. Disconnect power to the unit.

2. Remove the inner tub.

3. Remove the front panel.

4. Disconnect the pump inlet hose from the

outer tub outlet.

5. Remove the screws located on each side

of the tub brace bolts which secure the

tub to the tub support.

6. Remove the mounting screws on the in

side of the tub which mount the tub to the
bearing and seal housing.

7. Disconnect air dome hose.

8. PROTECT THE AIR BELL NIPPLE and lift

the tub from the cabinet.

NOTE: The air bell nipple is fragile, handle
carefully.

NOTE: When reinstalling the tub assembly,

be sure to:

• Protect the air bell nipple.

• Clean all connecting surfaces to ensure

proper sealing.

•

Position the gasket and seal on the bear
ing and seal housing.

• Tighten all screws securely.

PUMP ASSEMBLY

Pump

Housing

Impeller

Seal

Assembly

Plate & Pulley

Assembly

Figure 5-8

16009485-01

Section 5. Water Related Components

5-5