Maytag Atlantis User Manual

Page 69

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

TRANSMISSION REMOVAL

The transmission assembly can be removed
from the washer cabinet after removing the

drive belt, spin basket, outer tub and the sus
pension springs.

NOTE: // the "O" ring is to be reused, be ex
tremely careful not to damage it during the

removal.

To assist in correctly positioning the tub, a

small indentation has been formed on the tub
support just above one of the tub brace
mounting areas. This is the left front tub brace.

When the tub is in proper position and ready
to be mounted to the tub support, the large
tub cover lock (on the side of the tub) should

be located directly above the indentation and

tub brace (See Page 7-16).

Remove the "O" ring and agitator once the
drive train is back in place.

The transmission assembly, when removed

as described, will have the related components
assembled to it. These related components
should be examined carefully before reinstall
ing.

IMPORTANT

When installing the transmission, it is

necessary that the tub be located on the

tub support a certain way if all the
mounting holes are to be properly
aligned. This should be done before at
tempting to mount the tub to the bear
ing and sea! housing.

16009485-01

Section 7. Transmission And Related Components

7-15