Potter PFC-4410RC - Manual (Page 23)

23
PFC-4410RC • 5403550 • REV Q • 11/12
Program #1 Mode
1. Apply power to panel.
2. Move the program switch down.
3. Press the FUNCTION (bottom) button until the display reads “PASSWORD = 000”.
4. To enter a password, press the SELECT button until the proper number is displayed above the ^ symbol, then press the SET
button to move to the next digit. After entering the third number the display will change. (All panels are shipped with a 000
password.)
5. Press the FUNCTION (bottom) button until the display reads “PROGRAM #0”.
6. Press the SELECT button until the display reads “PROGRAM #1”.
7. Press the SET button.
8. The panel is completely programmed except for the custom banner and zone messages. Move the program switch back up.
Description: Single hazard - 3 zone
Inputs: 2 detection zones, 1 waterflow zone, 1 manual release zone, 2 supervisory zones
Outputs: 1 general alarm bell, 1 waterflow bell, 1 solenoid release circuit, 1 supervisory bell
Operation: Activation of either detection zone or the manual release zone will operate the release circuit and general alarm output.
Activation of the waterflow zone will operate the waterflow bell output.
Activation of the supervisory zone will operate the supervisory bell output.
When either zone 1, 2 or 4 is in alarm - output #1 (general alarm) and output #3 (solenoid release) will operate.
When zone 3 is in alarm - output #2 will operate (waterflow bell).
When the supervisory zone is activated - output #4 will operate (supervisory bell).
PROGRAM #1
ZONES
SUP 1 SUP 2 #1 #2 #3 #4
OUTPUTS Supervisory Detection Detection Waterflow Manual
Release
#1 ALARM INDICATING X X X
#2 ALARM INDICATING X
#3 RELEASE X X X
#4 SUPERVISORY X X