EVCO EVCLC33DJ2 User Manual
Page 57
EVCO S.p.A.
Vcolor 338 L | Installer manual ver. 2.0 | Code 144VC338LE204
page 57 of 66
No connection
ALARM
user interface-control module communication alarm
solutions:
-
check user interface-control module connection
main consequences:
-
if the alarm occurs when the device is on, a cooking cycle cannot be started
-
if the alarm occurs during a cooking cycle, no consequence
Temperature
ALARM
maximum temperature alarm
solutions:
-
check the temperature detected by the environment probe; see parameters A0, A1 and A3
main consequences:
-
no consequence
Board
temperature
alarm
ALARM
use temperature alarm.
solutions:
-
check the use temperature of the control module; see parameter A4
main consequences:
-
if the alarm occurs when the device is on, a cooking cycle cannot be started
-
if the alarm occurs during a cooking cycle, the cycle will be interrupted
-
the air vent will be opened, the technical compartment fan will be switched on and the remaining
outputs will be switched off.
door micro switch input alarm
solutions:
-
check the causes of the input activation; see parameter i0
main consequences:
-
if the alarm occurs during a cooking cycle, the temperature regulation output, the fan and the
steam injection output will be switched off and the vent will be opened
Circuit breaker
protection ALARM
fan circuit breaker protection input alarm
solutions:
-
check the causes of the input activation; see parameters i1 and i2
main consequences:
-
if the alarm occurs during a cooking cycle, the temperature regulation output and the fan will be
switched off
Peak absor.
ALARM
electric absorption input alarm
solutions:
-
check the causes of the input activation; see parameter i4
main consequences:
-
if the alarm occurs during a cooking cycle, the outputs will be switched off
Boiler probe
ALARM
boiler probe alarm
solutions:
-
check the probe type; see parameter P0
-
check the device-probe connection
-
check the boiler temperature
main consequences:
-
the boiler temperature regulation output will be deactivated