EVCO EVCLC33DJ2 - Manual (Page 31)

EVCO S.p.A. Vcolor 338 L | Installer manual ver. 2.0 | Code 144VC338LE204
page 31 of 66
8.3 Starting the cooking cycle
Once the cooking cycle has been launched, preheating will
start.
Opening and closing the door or pressing on the status bar
causes the machine to start the first phase of the cooking
cycle.
During preheat and during the cooking cycle, the display
shows the value of the variables affected by the process and
the relative setting.
To modify the settings; see the paragraph 8.2 “Setting the
cooking cycle”.
Touch:
- to open/close the air vent
- to switch the environment light on/off
- to display the value of the process variables
and machine status.
On conclusion of the cooking cycle, the buzzer is activated for
the time established with parameter c0.
Operate as follows to extend the cooking cycle:
3. Touch .
A screen enabling the extension of the cooking
cycle is displayed.
4. Touch the slide bar
to set the desired value
5. Touch the green icon to confirm.
8.4 Stopping the cooking cycle
Operate as follows to stop the cooking cycle:
1. Make sure no procedures are in progress.
2. Touch for 1 s.
Starting the cooking cycle and Pre-heat
End or interruption of the cooking cycle
Extension of the cooking cycle.
P R O L U N G A ?
FINE COTTURA 125min fase 3/3
S T O P S T O P
3.
2.