EVCO EVCLC33DJ2 User Manual
Page 55
EVCO S.p.A.
Vcolor 338 L | Installer manual ver. 2.0 | Code 144VC338LE204
page 55 of 66
17
USE OF THE USB PORT
17.1
Preliminary information
Through the USB port it is possible to make the following
operations:
-
upload and download of the settings contained in
the recipes from the “MY COOKBOOK” function
and from the “Special cycles” function work cycles
(hereinafter called “programs”)
-
upload and download of the settings contained in
the configuration parameters.
The operations are guaranteed with the use of the USB flash
drive EVUSB4096M.
The upload operations are allowed on condition that the
firmware of the device of origin is the same as that of the
device of destination.
17.2
Upload
of
the
settings
contained in the programs
To make the upload of the settings contained in the programs,
operate as follows:
1.
Ensure that the device is switched off and that no
other procedure is in progress.
2.
Plug in a USB flash drive containing a proper text
document called “prog.txt” in the USB port of the
device and wait a few seconds.
3.
Touch “UPLOAD PROGRAMS”.
4.
Touch
to confirm.
5.
At the end of the upload remove the USB flash
drive from the USB port of the device.
17.3
Download
of
the
settings
contained in the programs
To make the download of the settings contained in the
programs, operate as follows:
1.
Ensure that the device is switched off and that no
other procedure is in progress.
2.
Plug in a USB flash drive in the USB port of the
device and wait a few seconds.
3.
Touch “DOWNLOAD PROGRAMS”.
4.
Touch
to confirm.
17.4
Upload
of
the
settings
contained in the configuration
parameters
To make the upload of the settings contained in the programs,
operate as follows:
1.
Ensure that the device is switched off and that no
other procedure is in progress.
2.
Plug in a USB flash drive containing a proper text
document called “prog.txt” in the USB port of the
device and wait a few seconds.
3.
Touch “UPLOAD PARAMETERS”.
4.
Touch
to confirm.
5.
To the end of the upload remove the USB flash
drive from the USB port of the device.
17.5
Download
of
the
settings
contained in the configuration
parameters
To make the download of the settings contained in the
programs, operate as follows:
1.
Ensure that the device is switched off and that no
other procedure is in progress.
2.
Plug in a USB flash drive in the USB port of the
device and wait a few seconds.
3.
Touch “DOWNLOAD PARAMETERS”.
4.
Touch
to confirm.