EVCO EVCLC33DJ2 - Manual (Page 34)

EVCO S.p.A. Vcolor 338 L | Installer manual ver. 2.0 | Code 144VC338LE204
page 34 of 66
The following table illustrates the factory settings of the timed
proofing cycle.
SETTING DEFAULT
MINIMUM...
MAXIMUM
work set-point 30 °C 20... 50 °C
humidification 80 %. 40... 100 %.
duration of the
phase
120 min 1... 300 min
fan speed minimum
air vent opening on conclusion of the cycle
The following table illustrates the factory settings of the
environment cooling cycle; the opening and closing of the door
does not cause any consequence.
SETTING DEFAULT
MINIMUM...
MAXIMUM
work set-point
50 °C
(param. r11)
0... 500 °C
fan speed
maximum, without inversion of
rotation direction (if envisioned)
air vent opening
at the start of the cycle, for the
entire duration of the same
10.2 Starting a special cycle
Operate as follows to start a special cycle:
1. Ensure that the device is switched on and that no
other procedure is in progress.
2. Touch the "specials" key
3. Touch the identification icon of the special cycle.
4. Then touch to start the
cycle
Note: In the picture on the left (Start a special cycle) the
special cycle refers to leavening, but the procedure is
the same as that for the start of all the remaining
special cycles: regeneration, cooling and cleaning.
Access to a special cycle.
Starting a special cycle.