Kenwood KRF-V8881 D - Manual (Page 67)

VR-2090/VP-2aaO/Kf=IF-Va8eiD/KRF-V7771D(En/KÍ
Memory backup function
Please note that the following items will be deleted from
this unit's memory if the power cord is disconnected
from the AC outlet for approximately three days,
• The input selection is cleared and the "Tuner" input is selected.
• The volume setting is cleared and the volume is set to
"-66 dB",
• The receiving band setting is cleared and the "FM" band is
selected.
• The frequency setting is cleared and 87.5 MHz Is selected.
• The preset station memory is cleared.
• The surround setting is cleared and reset to the initial condition
Remote control unit
• Replace with new batteries.
• Operate the remote control unit within the
controllable range.
• Connect properly referring to "System con­
nection",
• Place the tape(s) or disc in the source compo­
nent to be played.
Remote control operation is not possible. • Batteries are exhausted
• The remote control unit is too faraway from the
main system, controlling angle is
too
large, or
there IS an obstacle in between.
• The audio cords and system control cords are
not connected properly,
• The source component tobe operated does not
contain the tape(s) or disc.
The ftC screen is not displayed. • Batteries are exhausted. • Replace with new batteries,
The RC display is abnormal. • Batteries are removed while something is dis­
played.
* Remove and replace batteries after the infor­
mation display has disappeared.
Setup Codes chart
Although each setup code is designed to work with a number of different models, certain codes may not work with some
models. (Also, certain codes may only operate some of the functions available on a given model.}
With some models, be sure to keep the ENTER key pressed for a while.
inquiries an the setup codes loaded using the free-Phone Consumer Help Line:
If there is any inquiry related to these setup codes, please contact the following services.
U.S.A. ; 1-800-753-9860 Canada : 1-800-644-0073
fortheU,S.A.
FCC WARNIMG
This equipment may generate or use radio frequency energy. Changes ormodif ¡cation s l o t his equipment may cause harmful interference unless
the modifications ara expressly approved in the instruction rnanush The user could lose the authority to operate this equipment if an
unauthorized change or modification ts made.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. 1 hese
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment may cause
harmful interference to radio communications, if it is not installed and used in accordance with the instructions. However, there is no
guarantee that irsterference will not occur in a particular Installation. If this equipment does cause harmful interference to radio or television
rsception, which can be datermined by turning the equipment off and on. the user is encouraged to try to correct the interference by one
or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver
— Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
— Consult the dealer or an experienced radio / TV technician for help.
For the U.S.A.
Note to C4ï¥sKsfeni installer:
This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC that provides guidelines for proper
grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point
of cable entry as practical. ____
Do not use contact cleaning agents because they could esse a malfunction. Be specifically careful against using contact cleaning agents
containing oil, since they may deform the plastic components.