Kenwood KRF-V8881 D - Manual (Page 14)

ti!
?*: \
VR-2O9G/Vn-ma0/KRF-veaS10/KRr-y/;7ir: ÍCr.^KI ""
MUTE incírcaTor Multi-mode dfspiay
©POWER key
(U.S.A., U.S.Military and Canada)
Press to switch power ON and OFF.
©POWER key
[Except for U.S.A., U.S.Military and Canada)
(China ; ©POWER)
Press to switch the main power ON and OFF,
©ON/STANDBY key
{Except for U.S.A., U.S.Military and Canada)
Press to switch the power mode between
STANDBY and ON.
©STANDBY indicator
Lights in STANDBY mods.
®RC sensor
Receives signals transmitted from the re­
mote contfoi unit.
©PHONES jack
Use for iistemng toaudio through headphones.
©SPEAKERS keys
Press each key to switch the SPEAKERS A or
SPEAKERS B ON and OFF.
©indicators
CilP INDICATOR :
Lights when the input is clipped during
analog to digital signal conversion, —(¿2
DOLBY DIGITAL ;
Lights when Dofby Digital is activated.
~m
DTS ;
Lights when the DTS is activatsd, ~SE]
©MUTE key
Press to mute the audio temporarily. —f3S
®HC transmitter
Sends signals to the remote control unit,
©indicator
Lights when signal is input from or output to
the remote control unit.
©VOLUME control knob
Rotate to adjust the volume,
©S VIDEO input jack
¡Except for the VR-20S0 or the KRF-V7771D
for the U.S. Military destination)
Connect the S VIDEO output jack of an AV
coftiponent.
©VIDEO input jack
Cormect the composite video output (RCA)
jack of an AV component.
©AUDIO (L, R} input jacks
Connect theaudio output fRCA) jacks of an AV
component.
©C02/TAPE2 MONITOR indicator
Lights when the CD2/Tape2 {Monitor) inputis
used.
-Qa;
©DISPLAY MODE key
Press to switch the dispiay on the main unT.
©INPUT SELECTOR key
Press to switch the input as shown below
TUNER
CD1
MD/Tapet
VIDE01
VIDE02
VIDEOS
VIDE04
AVAUX
PHONO
STANDBY indication
White standby indicatof is indicated, a small ernount of power is supplied to the system to back up the memory. In this mode, the system can be
turned ON by remote control.