Kenwood KRF-V8881 D - Manual (Page 65)

The sound quality and the volumes of the speakers can be adjusted as required, ^
Use the procedure on this page to adjust the audio individually, on a per-source or per-program (movie) basis.
The effects of the loudness and tone setups are applied only to the sounds output from the "L" and "R" front speakers.
The loudness or tone control effect is maximized when "Lstn Mode" is set to "Stereo".
Therefore, when the front speakers are set to "Nml" (Normal), low-frequency components are output from the subwoofer so
the loudness and tone effects are minimized.
VH-2Q9O/VR.2O0O/KHF.VBaB1 □/KRF-V77710 (E ki /K|
XtStar. •
Seiectthe "Main Menu" icon.
f....
O Select the "Snd" icon from the "Main Menu screen to
display the "Sound" menu screen.
[М Ijjfil GO GO 633 6!I3 ^ET Гивв* *|
TVf vweet vidima Videoa l__—1 L_i22j
Perform operation in the "Sound" menu screen.
O Adjust the Loudness.
This can be switched between and On -»Off.
SP Level - Speaker level
; Midnight mode
© Set the midnight mode.
This setting is possible only with the Dolby Digital (AC-3)
input source.
This can be switched in order of i -» 2 Off.
• When adjusting the Tone, go to step B-
• When adjusting the speaker level, go to step И-
Adjust the "Tone".
I Select the "Tone" icon in step I
О Set "Tone" to "On" or "Off".
® Adjust "Treble".
© Adjust "Bass".
Adjust the "SP Level"
C rCenter speaker
RS [Right Surround
speaker
LS [Left Surround
speaker
SW [Subwoofer
• Seieot the "SP Level" icon in step S.
• To return to step B from step H, select the ” 0 " (checkmark)
icon.
• The speaker volumes adjusted here is onty temporal.
These settings are returned to the setups made using "Setup"
chapter when the power is switched off or another input is
selected. _ __
• The speakers which have not been set up In the "SP Selection"
or "SP Selection (Custom)" menu screen under the "Setup
Surround" menu are displayed as in the "SP Level" menu
screen,
Q Adjust the level of each speaker.