Kenwood KRF-V8881 D - Manual (Page 23)

Code selection after mode download
After successful completion of the download, step □ of the previous page, the remote control automaticaily enters a special set-up mode which works
as described debw.
Select the input and component names that you want to assign a setup code.
ШмШШЗЩШШВВШШШШЩ!
Next I
f^l Device lO' '' ]
0i
O Select the input name by selecting the "or ” icon on
both sides of "Selector" (input selector),
This changes the section of "Videol" in the figure.
® Select the component name by selecting the “(3) "or "(Q "
icon on both sides of "Device" (componertt connected to the
rear panel input jacks).
This changes the section of "VCR" in the figure.
© Select the "Mext" icon.
The "Register info.2" menu screen appears.
Find out the numeric icon that outputs the power code of the component
• Find the code with which "Device" of Q can be operated.
© Select the " fi~l" Icon to output its power code,
* After selecting a numeric icon, be sure to press th® Joy stick key
to output its power code
©Select numeric icons in order from"ГП"until the compo­
nent selected in step □ is turned ON (i.e, repeat step О for
each numeric icori).
© Make sure that the component is turned on.
© Select the "Erttr" icon.
Select the "П~1" icon to output the power code of the first component on your list in step И of the previous page Continue to select icons
through "(5SJ" until the component you warrt to register turns on.
Though the "Futureset" memory In your remote control is quite large, only 20 different devices power codes can be put on the keypad at any
one time, if you require a larger download, the standard .setup procedure can be used. See "Assigning the connected components to the
selected inputs", your customer service representative can supply you with the downloaded setup codes numbars.
Set up all the downloaded codes.
Repeat the operations of steps О and Ш. I The setup code for the last power code to be sent in step © is
automaticaiiy registered at the iocation selected in step II.
End of operation.
To delete a setup code
Setup IR
« “#0000" is displayed when the setup code is inputted while the
"Setup IR" menu screen is shown.
(The input number is not shown,j
■ When a setup code has been downloaded, the section where
"#0000" IS shown above displays "#---------(The number input in
step © is not showrr.i
When setup codes of more than one components have been
downloaded, note that ali of the codes are interrelated between
each Dther, Therefore, if any of them is deleted, you should
perform the procedure of "Setup of components which are not
listed in the Setup Codes chart" from the beginning.
Operation for displaying the menu screen shown on the left:
©Selectthe "Main Menu" icon,
® Select the "Stp" icon.
© Select the “IR" icon.
Operation for deleting a setup code :
© Select the component to be deleted.
Select the component with the "or " icon.
0 Select the 4 digit code "9999".
© Select the "Entr" icon.