beautypg.com

Order of radio station presetting, Manual memory of broadcast stations, O select the “tuner " icon – Kenwood KRF-V8881 D User Manual

Page 52: Wl perform operation in the “tuner" menu screen, Receiving a manually preset station, Receiving a preset rds station, Manual memory of broadcast staiiom

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

wa-aoga/VR-soao/KfiF-vasa

i

o

/

krf

-

v

7 7 7

i

□ ¡en/K)

The Auto Memory function gives precedence to RDS sta­
tions and assigns them from preset number 1. Therefore,

when it is required to preset RDS stations as wel! asnon-RDS
stations, execute the Auto Memory operation first then
proceed to the manual memory operation of non-RDS sta­
tions.

Order of radio station presetting

Other stations than the RDS stations can be stored in the

preset memory by presetting them after the RDS stations

^ preset by Auto Memory as shown below or overwriting the

RDS stations preset in some preset numbers.

Preset number

1 2 ................................................................................... 39 40

5 Auto Memory

RDS stations

FM stations)

(5)

Manual memory

FM stations
or AM stations

Manual memory of broadcast stations

O Select the “Tuner " icon.

fSStl o a

fMftikJi ctíT

WfV 0057 ESoíl

T.p.»T T.p.3 loiiiuij |«ru»8t|j

Esa BH

m m , s m

Wl Perform operation in the “Tuner" menu screen.

FM 108.00MHz ■§ 11ch

rAutoll Band!

j^RDS]f

Direct

Memory/

lOkey Pad

M Perform operation in the "Memory/Wkey Pad"

menu screen.

Memory/IOkev Pad

[ Auto Memory |j

• Apartfrormhe auto memory function, RDS stations can also be Stored

manuaHy in the preset memory

■ In the manual msmory storage operation of radio stations, it may take

a few saconcts after the "Memory" icon is selected till the memory
display starts to blink depending on the receiving condition,

0 Select the receiving band.

Select the "Band" icon.

© Select a station or frequency.

Select the "@)"or “(g) ” icon.

© Select the "Memory/IOkey Pad",

© Select "Memory" icon.

• The memory mode "IfiHSWlIt" and preset call mode "[Mernprs;'!"

are switched alternately every time the icon is selected.

© Select one of the preset numbers from 1 to 40.

Select numeric icons as follows...

To preset in "15"................¡+10| [1]

• Repeat steps

B.S

lor each of the stations to be stored in memory,

• if a station IS stored in a preset number which has already stored

a station memofy under it, the previous memory is replaced by the
new mernory content.

• If RDS stations are stored manually in the preset memory, the PS

may not be included in the memory depending on receiving
conditions.

Receiving a manually preset station

Operation in the "Memorv/IOkey Pad" menu screen

Memory/10key Pad

0

O Select the preset number (up to 40I of the desired preset

station.

Select numeric icons as follows,.,

To receive in "20" l+iol |t1Q| [ol

« If you make a mistake m entering the figure of 10, select the ra

icon repeatedly until the original display is shown, then enter the
correct number.

Receiving preset stations in the preset order (P. CalU

Operation in the "Tuner" menu screen

Tuner

Freq.

P.Caii

FM 108.00MHz H 11cb

AutcTll Band

[RDS

If

Direct

Memory/

lOkey Pad

O Select the "Q "of "(Q" icon of "P.Calt".

When "ip.caiiiB" icons are selected

f

01^02—03'

When "fTjlp.caiil" icons are selected

•38*39-40

I

———

j

01-02—03..........38-39-40

■ Every time the icon is selected, the next station in the order of the

preset number is received.

If the icon is held selected ... Preset stations will be received suc-

cessivelyforabout half a second each.

This manual is related to the following products: