Kenwood KRF-V8881 D - Manual (Page 11)

Connecting the antennas
VR^PQ9Q/VR-S080/KRf'-veSSl D/KHF-V7771D (En/K)
^si^zzssBSBHH
Make connections as shown below.
Do not connect the power cord to a wall outlet until all connections are completed.
Antenna terminal connections
O Push lever. © Insert cord. © Return lever.
AM loop antenna
The supplied loop antenna is for use indoors. Place it as far as possible
from the receiver, TV set. speaker cords and power cord, and ad|ust the
direction for best reception.
FM indoor antenna
The supplied rndoor antenna is for temporary use only. Far stabie signal
reception we recommend using an outdoor antenna. Disconnect the
indoor antenna whers you connect one outdoors,
FM outdoor antenna
Lead the 75il coaxial cable connected to the FM outdoor antenna into
the room and connect it to the FM 7SH terminal.
FM DE-EMPHASIS/CHANNEL SPACE switch
(Except for U.S.A , Canada, China and Australia f
The FM DE-EMPHASIS/CHANNEL SPACE switch on the rear panel Is
set to the correct setting that prevails in the area to which the unit Is
shipped. However, if the FM DE-EMPHASIS/CHANNEL SPACE setting
Is not matched to the area where the unit is to be used; for instance,
when you move from area 1 to area 2 or vice versa, desired reception of
AM / FM broadcasts is not expected. In this case, change the FM OE-
EMPHASIS / CHANNEL SPACE setting in accordance with the area
corresponding to the tabie. The FM DE-EMPHASIS is switched over at
the same time.
• When changing the setting of the FM DE-EMPHAS!S / CHANNEL
SPACE switch, first disconnect the power cord, then reset the channel
space switch, connect the power cord again, and turn the power on.
li-nMOlO fR,,-
CHAMMEL
opArc AM IDkHz
»p-Mi-i: lOQkWz
:
q
SQ^s
AM 3 k H z
FM 5DkHi
Area
CHANNEL
SPACE freq.
FM
DE-EMPHASIS
I
U.S.A., Canada,
1 and South Ameri-
1 flan countries
FM: 100kHz
AM: 10 kHz
75 jj S
2 Other countries
FM: 50 kHz
AM: 9 kHz
50 MS