Kenwood KRF-V8881 D - Manual (Page 25)

Vn- 20 g 0 /Vn- 20 SO/KRF-V 8 S 81 D/KRF-V 7771 D ̣n/K]
Preparation
• Connect the CD playeris) to the main unit, and perform the
operations m "Assigning the connected components to the
selected inputs" and "Setup of Room A and Room B"
To piay CD{s) in Room A and Room B, u$e one of the three
kinds of connection methods below.
Connecting a KENWOOD Multi-room capabilitv CD player.
Connecting two CD players.
Connecting a CD player other than KENWOOD Multi-room
capability CD Player
Setup for playing CDs in Room A and Room B using a Multi-room capability CD Player
Connect the Multi-room capability CD player.
To use the Multi-room capability CD Player from KENWOOD, connect its OUTPUT A to the "CD1" input jacks on the rear panel of the main
unit so that OUTPUT A is remote controlled as the CD1 input. Then connect OUTPUT B to the CD2/TAPE2 MONITOR input Jacks on the rear
panel so that OUTPUT B is remote controlled as the "CD2" input.
Connect the Multi-room capability CD Player and the main unit with a system control cord.
Operation in the "Setup Multi Room" menu.
Setup Multi Room
li Multi Room 11 Yes
|[ Zone Select 11 Room A
• Display The "Setup Multi
Room" menu screen
• To listen in "Room A", set
"SPEAKERS A" to ON.
• To tistsn in "Room B", set
"SPEAKERS B" to ON.
Operation for displaying the "Setup Multi Room" menu screen :
O Select the “Main Menu" icon.
O Select the "Stp" icon,
© Select the "Mult! Room" icon.
Operation in the "Setup Multi Room" menu screen :
© Select and set the "Multi Room" icon to "Yes".
©Select and set the "Zone Select" icon to "Room A" or
"Room B" accordirtg to your location.
© Press and hold the "DISPLAY MODE" key on the main unit
for more tharr 2 seconds to set the IR RECEIVER location to
"IR RECEIVER B".
Operation in the "Setup Input" menu.
Setup Input ^ • Display the "Setup Input"
mersu screen.
• In this screen, perform the
setup for controlling ''CD2",
Operation for displaying the "Setup Input" menu screen :
O Select the "Main Menu" icon.
® Select the "Stp" icon.
© Select the “Input" icon.
Operation in the "Setup Input" mettu screen :
© Select and set the "CD2/Tape2" icon to "CD2".
Setup IR
In step Oof the procedure in "Assigning the connected com porjents to the selected inputs", select the "CD1" input and input "gl [|][i] g]'
(system control code) as the "Setup IR" code. Also input " [s] [¥) g [g]" for the "CD2" input.