Cisco OL-21636-01 - Manual (Page 86)

5-4
Cisco IP Solution Center L2VPN and Carrier Ethernet User Guide, 6.0
OL-21636-01
Chapter 5 Creating a FlexUNI/EVC ATM-Ethernet Interworking Policy
Setting the Service Options
Setting the Service Options
This section describes how to set the service options for the FlexUNI/EVC policy, as shown in
Figure 5-2 .
Figure 5-2 EVC Policy Editor - Service Options Window
The Editable check box gives you the option of making a field editable. If you check the Editable check
box, the service operator who is using this FlexUNI/EVC policy can modify the editable parameter
during FlexUNI/EVC service request creation.
To set the FlexUNI/EVC service options, perform the following steps.
Step 1 Check the CE Directly Connected to FlexUNI check box if the CEs are directly connected to the N-PE.
This check box is not checked by default.
Usage notes:
• If the check box is checked, a service request created using this policy can have only directly
connected links. No Ethernet access nodes will be involved.
• If the check box is unchecked, a service request created using this policy might or might not have
Ethernet access nodes in the links.
• When a CE is directly connected to the N-PE, NPCs are not applicable to the link while creating
service requests.
• When a CE is not directly connected to the N-PE, NPCs are used during service request creation, as
per standard ISC behavior. There is no change in NPC implementation to support FlexUNI/EVC
functionality.
Step 2 Check the All Links Terminate on FlexUNI check box if all links need to be configured with
FlexUNI/EVC features.
This check box is not check by default. Usage notes:
• If the check box is checked, a service request created using such policy will have all links using the
FlexUNI/EVC feature.