Cisco OL-21636-01 - Manual (Page 108)

6-6
Cisco IP Solution Center L2VPN and Carrier Ethernet User Guide, 6.0
OL-21636-01
Chapter 6 Managing a FlexUNI/EVC ATM-Ethernet Interworking Service Request
Setting the Service Request Details
A dialogue appears in which you can enter a description.
Step 9 To set up direct connect links, see the section Setting Direct Connect Links, page 6-8 .
Step 10 To set up links with L2 access nodes, see the section Setting Links with L2 Access Nodes, page 6-22 .
Local Core Connectivity
If the MPLS Core Connectivity Type for the FlexUNI/EVC ATM-Ethernet Interworking policy is
LOCAL, the EVC Service Request Editor window shown
Figure 6-2 appears.
Figure 6-2 EVC Service Request Details Window for Local Core Connectivity
Perform the following steps to set the attributes in the first section of the Service Request Details
window:
Step 1 The Job ID and SR ID fields are read-only.
When the service request is being created for the first time, the fields display a value of NEW. When an
existing service request is being modified, the values of the fields indicate the respective IDs that the ISC
database holds within the editing flow of the service request.
Step 2 The Policy field is read-only.
It displays the name of the policy on which the service request is based.
Step 3 Click Select VPN to choose a VPN for use with this service request.
The Select VPN window appears with the VPNs defined in the system.