Flexuni/evc (autopick service instance name) – Cisco OL-21636-01 User Manual
Page 319
A-41
Cisco IP Solution Center L2VPN and Carrier Ethernet User Guide, 6.0
OL-21636-01
Appendix A Sample Configlets
FlexUNI/EVC (AutoPick Service Instance Name)
FlexUNI/EVC (AutoPick Service Instance Name)
Configuration
•
FlexUNI(EVC)/Metro Ethernet.
•
Feature: FlexUNI/EVC with AutoPick Service Instance Name enabled and the Service Instance
Name input field left blank.
•
Device configuration:
–
The N-PE is a Cisco 7600 with IOS 12.2(33) SRB3.
Interface(s): GigabitEthernet7/0/2.
–
The U-PE is a Cisco 3750ME with IOS 12.2(25) EY2.
Interface(s): FastEthernet1/0/14.
Configlets
Comments
•
The transport type is pseudowire.
•
The autopick Service Instance Name will take the value CustomerName_JobID.
U-PE
N-PE
!
vlan 452
exit
!
interface FastEthernet1/0/10
no ip address
switchport trunk allowed vlan add 452
!
interface FastEthernet1/0/13
no spanning-tree bpdufilter enable
switchport
no keepalive
no ip address
switchport
switchport trunk encapsulation dot1q
switchport mode trunk
switchport trunk allowed vlan 452
switchport nonegotiate
mac access-group ISC-FastEthernet1/0/13 in
!
vlan 3524
exit
!
ethernet evc C1_1
!
interface GigabitEthernet7/0/0
service instance 3 ethernet C1_1
encapsulation dot1q 452
rewrite ingress tag pop 1 symmetric
bridge-domain 3524 split-horizon
!
interface Vlan3524
no ip address
description BD=T,SVI=T,Flex
xconnect 22.22.22.22 52500 encapsulation
mpls
backup peer 22.22.22.22 52501
no shutdown