Ews (epl) (point-to-point) – Cisco OL-21636-01 User Manual
Page 294
A-16
Cisco IP Solution Center L2VPN and Carrier Ethernet User Guide, 6.0
OL-21636-01
Appendix A Sample Configlets
EWS (EPL) (Point-to-Point)
EWS (EPL) (Point-to-Point)
Configuration
•
Service: L2VPN/Metro Ethernet.
•
Feature: EWS (EPL) (point-to-point).
•
Device configuration:
–
The N-PE is a Cisco 7600 with IOS 12.2(18)SXF, Sup720-3BXL.
Interface(s): FA8/17.
–
The U-PE is a Cisco 3750ME with IOS 12.2(25)EY1. No port security, no tunneling.
Interface(s): FA1/0/20 – FA1/0/23.
–
L2VPN point-to-point.
–
Q-in-Q UNI.
Configlets
Comments
•
The N-PE is a 7600 with a OSM or SIP-600 module. Provisioning is the same as the ERS (EVPL)
example.
•
The U-PE is a generic Metro Ethernet (ME) switch.
•
No PACL provisioned by default. BPDU can be tunneled if desired.
•
The system MTU needs to set to 1522 to handle the extra 4 bytes of Q-in-Q frames.
U-PE
N-PE
system mtu 1522
!
vlan 774
exit
!
interface FastEthernet1/0/20
no cdp enable
no keepalive
switchport
switchport access vlan 774
switchport mode dot1q-tunnel
switchport nonegotiate
spanning-tree portfast
spanning-tree bpdufilter enable
!
interface FastEthernet1/0/23
no ip address
switchport trunk allowed vlan 774,787-788
vlan 774
exit
!
interface FastEthernet8/17
switchport trunk allowed vlan
1,451,653,659,766-768,772,773-774,878
!
interface Vlan774
no ip address
description L2VPN EWS
xconnect 99.99.8.99 89029 encapsulation
mpls
no shutdown