Figure 8-10 – Cisco OL-21636-01 User Manual
Page 175
8-9
Cisco IP Solution Center L2VPN and Carrier Ethernet User Guide, 6.0
OL-21636-01
Chapter 8 Managing an L2VPN Service Request
Creating an L2VPN Service Request
Figure 8-10
End-To-End Wire Editor
•
You can enter a description for the service request in the first Description field. The description will
show up in this window and also in the Description column of the Service Requests window. The
maximum length for this field is 256 characters.
•
You can enter a description for each end-to-end wire in the Description field provided for each wire.
The description shows up only in this window. The data in this field is not pushed to the device(s).
The maximum length for this field is 256 characters.
•
The ID number is system-generated identification number for the circuit.
•
The Circuit ID is created automatically, based on the service. For example, for Ethernet, it is based
on the VLAN number; for Frame Relay, it is based on the DLCI; for ATM, it is based on the
VPI/VCI.
Step 6
Click Add AC in the Attachment Circuit (A1) column.
The Attachment Tunnel Editor appears. (See
.)
Figure 8-11
Select CE for Attachment Circuit
Step 7
Click Select CE.
The Select CPE window appears. (See
.)