Cisco OL-21636-01 - Manual (Page 320)

A-42
Cisco IP Solution Center L2VPN and Carrier Ethernet User Guide, 6.0
OL-21636-01
Appendix A Sample Configlets
FlexUNI/EVC (No AutoPick Service Instance Name, No Service Instance Name)
FlexUNI/EVC (No AutoPick Service Instance Name, No Service
Instance Name)
Configuration • FlexUNI(EVC)/Metro Ethernet.
• Feature: FlexUNI/EVC with AutoPick Service Instance Name not enabled and the Service Instance
Name input field left blank.
• Device configuration:
– The N-PE is a Cisco 7600 with IOS 12.2(33) SRB3.
Interface(s): GigabitEthernet7/0/2.
– The U-PE is a Cisco 3750ME with IOS 12.2(25) EY2.
Interface(s): FastEthernet1/0/14.
Configlets
Comments • In this example, the user does not enable AutoPick Service Instance Name and also leaves the
Service Instance Name input field blank.
• The global command ethernet evc is not generated, while the command
service instance 43 ethernet is generated.
• There is no Service Instance Name available and the Service Instance ID is 43.
U-PE N-PE
!
vlan 566
exit
!
interface FastEthernet1/0/14
no spanning-tree bpdufilter enable
switchport
no keepalive
no ip address
switchport trunk encapsulation dot1q
switchport mode trunk
switchport trunk allowed vlan 566
switchport nonegotiate
no shutdown
mac access-group ISC-FastEthernet1/0/14 in
!
interface FastEthernet1/0/18
no ip address
switchport trunk allowed vlan 566
!
mac access-list extended
ISC-FastEthernet1/0/14
deny any host 0100.0ccc.cccc
deny any host 0100.0ccc.cccd
deny any host 0100.0ccd.cdd0
deny any host 0180.c200.0000
permit any any
!
interface GigabitEthernet7/0/2
service instance 43 ethernet
encapsulation dot1q 566
xconnect 1.1.1.1 453366 encapsulation mpls