Cisco OL-21636-01 User Manual
Page 85
5-3
Cisco IP Solution Center L2VPN and Carrier Ethernet User Guide, 6.0
OL-21636-01
Chapter 5 Creating a FlexUNI/EVC ATM-Ethernet Interworking Policy
Defining the FlexUNI/EVC ATM-Ethernet Interworking Policy
Figure 5-1
EVC Policy Editor - Service Type
Step 4
Enter a Policy Name for the FlexUNI/EVC ATM-Ethernet Interworking policy.
Step 5
Choose the Policy Owner for the FlexUNI/EVC policy.
There are three types of FlexUNI/EVC policy ownership:
•
Customer ownership
•
Provider ownership
•
Global ownership—Any service operator can make use of this policy.
This ownership has relevance when the ISC Role-Based Access Control (RBAC) comes into play. For
example, a FlexUNI/EVC policy that is customer-owned can only be seen by operators who are allowed
to work on this customer-owned policy. Similarly, operators who are allowed to work on a provider’s
network can view, use, and deploy a particular provider-owned policy.
Step 6
Click Select to choose the owner of the FlexUNI/EVC policy.
The policy owner was established when you created customers or providers during ISC setup. If the
ownership is global, the Select function does not appear.
Step 7
Choose the Policy Type.
The choices are:
•
ETHERNET
•
ATM-Ethernet Interworking
Note
This chapter describes creating the ATM-Ethernet Interworking policy type. For information on using
the FlexUNI/EVC ETHERNET policy type, see
Chapter 3, “Creating a FlexUNI/EVC Ethernet Policy.”
Step 8
Click Next.
The EVC Policy Editor - Service Options window appears, as show in
Step 9
Continue with the steps contained in the next section,
Setting the Service Options, page 5-4
.