Cisco OL-21636-01 - Manual (Page 242)

10-6
Cisco IP Solution Center L2VPN and Carrier Ethernet User Guide, 6.0
OL-21636-01
Chapter 10 Managing a VPLS Service Request
Creating a VPLS Service Request without a CE
Step 17 Continue to specify additional CEs, as in previous steps, if desired.
Step 18 Click OK.
Step 19 Click Save.
The service request is created and saved into ISC.
Creating a VPLS Service Request without a CE
This section includes detailed steps for creating a VPLS service request without a CE present. In this
example, the service request is for an VPLS policy over an MPLS core with an EMS (EP-LAN) service
type and no CE present.
Perform the following steps.
Step 1 Choose the appropriate VPLS policy.
The VPLS Service Request Editor window appears. (See Figure 10-7 .)
Figure 10-7 VPLS Service Request Editor
Step 2 Click Select VPN to choose a VPN for use with this PE.
The Select VPN window appears with the VPNs defined in the system. Only VPNs with the same service
type (ERMS/EVP-LAN or EMS/EP-LAN) as the policy you chose appear. (See
Figure 10-8 .)