Cisco OL-21636-01 - Manual (Page 146)

7-18
Cisco IP Solution Center L2VPN and Carrier Ethernet User Guide, 6.0
OL-21636-01
Chapter 7 Creating an L2VPN Policy
Defining an Ethernet EWS (EPL) Policy with a CE
Step 10 Check the VLAN ID AutoPick check box if you want ISC to choose a VLAN ID.
If you do not check this check box, you will be prompted to provide the VLAN in a Provider VLAN ID
field during service activation.
Step 11 Check the VC ID AutoPick check box if you want ISC to choose a VC ID.
If you do not check this check box, you will be prompted to provide the VC ID in a VC ID field during
service activation.
Step 12 Check the Use PseudoWireClass check box to enable the selection of a pseudowire class.
This attribute is only applicable for IOS XR devices. If the check box is checked, an additional attribute,
PseudoWireClass, appears in the GUI. Click the Select button of PseudoWireClass attribute to choose
a pseudowire class previously created in ISC. The pseudowire class name is used for provisioning
pw-class commands on IOS XR devices. See
Creating and Modifying Pseudowire Classes for IOS XR
Devices, page 2-10 for additional information on pseudowire class support for IOS XR devices.
Step 13 Choose an L2VPN Group Name from the drop-down list.
The choices are:
• ISC
• VPNSC
This attribute is used for provisioning the L2VPN group name on IOS XR devices.
Note The choices in the drop-down list are derived from a configurable DCPL property. For
information about how to define the L2VPN Group Name choices available in the drop-down
list, see
Defining L2VPN Group Names for IOS XR Devices, page 2-14 .
Step 14 Enter an E-Line Name to specify the point-to-point (p2p) E-line name.
This attribute is only applicable for IOS XR devices. If no value is specified for the p2p name, ISC
generates a default name consisting of the names of the two PEs forming the pseudowire, separated by
hyphens (for example, 6503-A----6503-B). If the default name is more than 32 characters, the device
names are truncated.
Step 15 Enter a VLAN NAME (optional) to specify a name to describe the VLAN.
The name must be one token (no spaces allowed.) The limit for the VLAN name is 32 characters. The
name has to be unique.
Step 16 Check the VLAN ID AutoPick check box if you want ISC to choose a VLAN ID. If you do not check
this check box, you will be prompted to provide the VLAN in a Provider VLAN ID field during service
activation.
Step 17 Enter a Link Media type (optional) of None, auto-select, rj45, or sfp.
Usage notes:
• The default is None.
• When this attribute is used, a new CLI will be generated in the UNI interface to define the media
type.
• The Link Media attribute is supported only for ME3400 platforms.
Step 18 Enter a Link Speed (optional) of None, 10, 100, 1000, Auto, or nonegotiate.
Step 19 Enter a Link Duplex (optional) of None, Full, Half, or Auto.