Cisco OL-21636-01 User Manual
Page 121
6-19
Cisco IP Solution Center L2VPN and Carrier Ethernet User Guide, 6.0
OL-21636-01
Chapter 6 Managing a FlexUNI/EVC ATM-Ethernet Interworking Service Request
Setting the Service Request Details
Step 1
In the Direct Connect Links section of the FlexUNI(EVC) Service Request Editor window, specify the
device for which you would like to set up an ATM link.
Step 2
Choose an ATM interface for the UNI.
Note
ATM interfaces are displayed in the drop-down list in the UNI column only if the FlexUNI/EVC
service request is based on an ATM-Ethernet Interworking policy type.
When you choose an ATM interface, the check box in the FlexUNI(EVC) column dynamically
disappears from the GUI.
Step 3
In the Link Attributes column, click the Edit link of the device on which you want to add an ATM link.
The ATM-Ethernet Attributes window appears, as shown in
.
Figure 6-7
ATM-Ethernet Attributes Window
All of the fields in the ATM-Ethernet Attributes window are enabled based on the policy settings.
Step 4
Choose the Transport Mode from the drop-down list.
The choices are:
•
VP—Virtual path mode. This is the default.
•
VC—Virtual circuit mode.
Step 5
Choose the ATM Encapsulation from the drop-down list.
•
AAL5SNAP
Step 6
To specify the ATM virtual channel descriptor (VCD)/subinterface number, enter a value in the ATM
VCD/Sub-Interface # field.
The value can be from 1 to 2147483647.
Step 7
To specify the ATM virtual path identifier (VPI), enter a value in the ATM VPI field.
The value can be from 0 to 255.