Cisco OL-21636-01 User Manual
Page 207
9-15
Cisco IP Solution Center L2VPN and Carrier Ethernet User Guide, 6.0
OL-21636-01
Chapter 9 Creating a VPLS Policy
Defining an MPLS/EMS (EP-LAN) Policy with a CE
Figure 9-12
UNI Port Security
Step 21
Check the Enable Storm Control check box (see
) to help prevent the UNI port from being
disrupted by a broadcast, multicast or unicast storm.
Enter a threshold value for each type of traffic. The value, which can be specified to two significant
digits, represents the percentage of the total available bandwidth of the port. If the threshold of a traffic
type is reached, further traffic of that type is suppressed until the incoming traffic falls below the
threshold level.
Figure 9-13
Enable Storm Control
Step 22
Check the Protocol Tunnelling check box (see
) if you want to define the Layer 2 Bridge
Protocol Data Unit (BPDU) frames that can be tunneled over the core to the other end.
Figure 9-14
Protocol Tunnelling
For each protocol that you check, enter the shutdown threshold and drop threshold for that protocol:
a.
Tunnel CDP—Enable Layer 2 tunnelling on Cisco Discover Protocol (CDP).
b.
CDP Threshold—Enter the number of packets per second to be received before the interface is shut
down.