Cub Cadet Z-Force S Series - Manual (Page 46)

Z-Force-S
40
5. Disconnect both of the drive control arms from the
speed selector plates. See Figure 5.28.
6. Start the engine and advance throttle to maximum
RPM.
7. Release the parking brake.
8. Watch both rear tires for movement.
See Figure 5.29.
NOTE: If there is no wheel movement, the hyrdo
transmissions are in neutral and don’t need
to be adjusted. Skip ahead to step 13.
NOTE: If one or both rear wheels move, the hydro
transmissions need to be adjusted. Continue
on to step 9.
9. With the engine still running, locate the socket head
cap screw in the slot of the speed selector plate on
the transmission that needs to be adjusted.
10. Loosen the socket head cap screw using a 1/4” hex
key. See Figure 5.30.
11. Adjust the speed selector plate until the wheel stops
moving.
12. Tighten the socket head cap screw using a 1/4” hex
key.
13. Turn-off the engine.
Figure 5.28
Drive control rods
Speed selector plates
Figure 5.29
No movement
Figure 5.30
socket head
cap screw