beautypg.com

Chapter 5: drive, Drive belt – Cub Cadet Z-Force S Series User Manual

Page 35

background image

Drive

29

The Z-Force S is built using two different models of HydroGear transmissions. The 48” deck version is equipped

with two HydroGear EZT transmissions. The 60” version is equipped with two ZT2800 transmissions.

The Hydro-gear shop manual for the EZT transmissions is form number BLN-52622. The Hydro-gear shop man-

ual for the ZT2800 transmissions is form number BLN-52441. These manuals are available through HydroGear.

Drive belt

The drive belt is the most common drive system compo-
nent that will need attention. To remove/replace the drive
belt:

NOTE: The procedure to replace the drive belt is the same

for both transmission models.

1. Remove the deck as described in chapter 8: Cutting

Decks and Lift Shaft.

2.

Set the parking brake.

3.

Lift and safely support the rear of the mower.

4.

Remove one of the rear wheels. See Figure 5.1.

5.

Loosen the idler pulleys using a pair of 9/16”
wrenches. See Figure 5.2.

6.

Slip the belt past the belt guides and off of the idler
pulleys.

Figure 5.1

Jack stands

Figure 5.2

Idler pulleys

CHAPTER 5: DRIVE