Brake shaft assembly – Cub Cadet Z-Force S Series User Manual
Page 18

Z-Force-S
12
Brake shaft assembly
To remove/replace the brake shaft:
1.
Remove the cutting deck by following the proce-
dures described in Chapter 8: Cutting Decks and
Lift shaft.
2.
Lift and safely support the rear of the mower.
3.
If the parking brake is set, release it.
4.
Disconnect the brake springs. See Figure 3.11.
5.
Disconnect the link that runs from the idler bracket
to the brake shaft by removing the cotter pin.
See Figure 3.12.
6.
Disconnect the adjustable drive links from the pivot
arms by removing the bow tie clips at the ferrule end
of the link. See Figure 3.13.
Figure 3.11
Brake springs
Figure 3.12
Link
Cotter pin
Figure 3.13
bow tie clip
Adjustable drive
links
See also other documents in the category Cub Cadet Special machinery:
- G1332 (20 pages)
- i1046 (36 pages)
- i1046 (32 pages)
- 54M (28 pages)
- 980 (20 pages)
- 949 (20 pages)
- Time Save (28 pages)
- 990 (24 pages)
- 997 (36 pages)
- V469 (20 pages)
- 4 Fabricated Deck (36 pages)
- 4 Fabricated Deck (32 pages)
- 6 Fabricated Deck (28 pages)
- 4 Fabricated Deck (32 pages)
- 4 Fabricated Deck (32 pages)
- 6 Fabricated Deck (36 pages)
- M48-M60-KW (28 pages)
- 4 Fabricated Deck (32 pages)
- 6 Fabricated Deck (32 pages)
- CC 500 BAT (30 pages)
- CC 22 (20 pages)
- CC 949 (13 pages)
- 33" Wide Area (29 pages)
- Z-Wing (88 pages)
- TANK S Series: Electrical System (9 pages)
- TANK S Series: Hydraulic Drive & Steering System (12 pages)
- TANK S Series: Steering System Adjustments (11 pages)
- 640 (24 pages)
- 640 (20 pages)
- 641 (24 pages)
- 641 (20 pages)
- J466 (32 pages)
- Series C460 (28 pages)
- 435A (24 pages)
- 642 (24 pages)
- 414 (24 pages)
- M465 (28 pages)
- Fun Runner (117 pages)
- 4 x 2 Big Country - Steel Bed (38 pages)
- 4 x 2 Big Country - Poly Bed & Steel Bed (82 pages)
- 4 x 4 Volunteer (328 pages)
- 6 x 4 Big Country (121 pages)
- CC 4BP 32cc (29 pages)
- 2518-48 (60 pages)
- 1525 (39 pages)