Kontron S4600 SEL Troubleshooting - Manual (Page 46)

Power Subsystems
System Event Log Troubleshooting Guide for EPSD Platforms Based on Intel ® Xeon ® Processor E5 4600/2600/2400/1600/1400 Product Families
36 Intel order number G90620-002 Revision 1.1
Sensor Specific Offset Description Next Steps
Hex Description
05h Soft Power Control
Failure Generally means power good was lost in
the system, causing a shutdown. This could be cause by the power supply subsystem or system
components.
1. Verify all power cables and adapters are connected properly (AC
cables as well as the cables between the PSU and system
components).
2. Cross test the PSU if possible.
3. Replace the power subsystem.
06h Power Unit Failure Power subsystem experienced a failure. Indicates a power supply failed.
1. Remove and reapply AC power.
2. If the power supply still fails, replace it.
4.3.2 Power Unit Redundancy Sensor
This sensor is enabled on the systems that support redundant power supplies. When a system has AC applied or if it loses
redundancy of the power supplies, a message will get logged into the SEL.
Table 17: Power Unit Redundancy Sensors Typical Characteristics
Byte Field Description
11 Sensor Type 09h = Power Unit
12 Sensor Number 02h
13 Event Direction and
Event Type [7] Event direction
0b = Assertion Event
1b = Deassertion Event
[6:0] Event Type = 0Bh (Generic Discrete)
14 Event Data 1 [7:6] – 00b = Unspecified Event Data 2
[5:4] – 00b = Unspecified Event Data 3
[3:0] – Event Trigger Offset as described in Table 18
15 Event Data 2 Not used
16 Event Data 3 Not used