Elecraft XV Assembly Manual for XV222 - Manual (Page 57)

- 54 -
Final Test and Alignment
In the following steps you will connect your transverter to your station
equipment and perform a complete alignment and test procedure.
Turn to the Installation Procedures in your Transverter Owner’s
Manual and follow those instructions to connect your transverter to your
other station equipment including the rig you will us for a 28 MHz I.F.
Perform the complete Alignment and Test Procedures in your
Owner’s Manual to properly adjust and calibrate your transverter and
verify that it is operating normally.
If you encounter any difficulties in the alignment and test procedures:
_ Carefully check your setup to ensure all cables are properly
connected.
_ Inspect again your parts placement and soldering on the PC
PCBs. Most initial difficulties are eventually traced to an
incorrectly placed component or a bad solder connection. The
circuit description and schematic diagrams in your Owner’s
manual can help you decide which circuits to check, based on
where in the alignment and test procedures you experience
difficulty.
_ Refer to the Troubleshooting information in your Owner’s
Manual for nominal voltages at key points in normal operation.
Congratulations
You have completed the assembly, test and alignment of your
transverter. Turn to your Owner’s Manual for complete installation and
operating instructions.
Your Owner’s Manual also describes modifications and optional
accessories for your transverter that you may choose to best integrate it
with your station equipment.