Elecraft XV Assembly Manual for XV222 - Manual (Page 10)

- 7 -
Parts Inventory
You should do a complete inventory. Contact Elecraft if you find anything missing.
i
Leave painted panels wrapped until they are needed during assembly. This will protect the finish.
Cabinet and RF PCB components used in all transverters.
Picture Ref. Designator(s) QTY Description Part #
1
Printed Circuit Board, XV, 50,144,222
i
Handle with care – ESD Sensitive. This PCB is supplied with a
number of surface-mount devices (smd) pre-mounted. Some of these
components are static-sensitive and vulnerable until other parts are installed
on the PCB. There is a temporary jumper across the solder pads for L1 on
the PCB to prevent static damage to Q3. Do not remove this jumper until
instructed to do so.
E100169
1 Front Panel E100153
1 Rear Panel E100154
See Figure 1 .
2 Side Panel E100140
1 Top Cover E100267
1 Bottom Cover E100268
1 Heat Spreader E100156
8 2-D Fastener E100078
2 Right Angle Bracket E700073
40 Pan Head Black Machine Screw, 3/16 inch. 4-40. E700015
5 Pan Head Zinc or Stainless Steel Machine Screw, 5/16 inch, 4-40 E700077
2 Pan Head Black Machine Screw, 1/2 inch, 4-40 E700030