AVer EH11116H-4 series user manual - Manual (Page 108)

98
- Relay Output
Set to enable/disable the relay operation when the alarm is activated and to extend additional time in
second before it stops the relay operation.
1. Beside the Relay Output check box, click Detail.
2. In the Alarm Relay dialog box, select from the available relay list and in the Status column, set to
on/off the relay operation when the alarm is activated.
3. In the Retrieve time check box, you may enable/disable to extend the relay operation time and set the
duration in second(0 ~3600 seconds).
4. Click OK to exit and accept the setting and Cancel to exit without saving the setting.
- IP Cam Relay Output: Set to enable/disable the relay operation when the alarm is activated.