AVer EH11116H-4 series user manual User Manual
Page 106
96
-
Video Loss: click the camera number (01 to 16) to set the alarm condition when video is lost. Click Detail
button to setup the system to send out the alarm when video is lost and status last the time that user has
entered in Continuous trigger duration.
6. In (4) Sensor, select and click on the sensor number to set the condition for the system to alarm. If the
sensor normal status is high, set the sensor condition to low.
-
IP Camera Sensor: To adjust sensor high/low that is connected on the IP camera.
-
Continue trigger duration: Set a time period that when sensor has been trigger and stay in the same
status for that period, then the alarm will be sent out.
-
Enable/disable the Abnormal Event check box, to set the condition of the event for system to alarm.
Reboot: when the DVR system reboot without abnormal condition, the system will send out the
alarm message.
Abnormal Reboot: when the DVR system reboot in irregular condition, the system will send out
the alarm message.
Recording is switched off: when the recording has been stopped, the system will send out the
alarm message.