Nikon LS-10 Installation Guide for Windows - Manual (Page 55)

Software Installation Chapter 5
Coolscan. This application has no menu. It will locate Coolscan, send the
E ject F ilm
command, then quit.
Nikon Installer Software
By responding to a few simple prompts and providing a minimum amount of
information, the Nikon Installer WiW automatically install the Nikon Scanner plug-in
and/or the Coolscan Control software onto your hard drive, as requested.
Commands that are taken from the user interface in this section are shown using
H elvetica type.
System Requirements
Windows 3.0 or later must be installed on the computer before attempting to run
the Nikon Installer software. The destination disk drive, the drive on which you will be
loading the scanning software, must have enough disk space to accommodate the Nikon
Scanner plug-in and/or Coolscan Control, and the SCSI driver. If you are planning on
using the Nikon Scanner plug-in with specific third-party applications, you should have
all the required disks available before continuing.
The Distribution Diskette
The Nikon software distribution diskette contains the Coolscan Control applica­
tion, the ASPI driver required by the SCI controller card, and the main installation pro­
gram called
S etup .E x E.
The
S etup .E x E
program will install Coolscan Control
and/or a number of third party applications you may already own. Make sure to make a
backup copy of the Nikon Distribution Diskette before continuing.
Running the Nikon Installer
First, insert the backup copy of the distribution diskette into an available 3-1/2
inch floppy disk drive. Please contact Nikon Technical Support at 516-547-4311 if you
require 5-1/4 inch media.
The Nikon Installer software must be run from Windows. In the Windows
Program Manager click the mouse on the F
ile
menu item, as shown in Figure 5.2.
Page 48
Nikon Coolscan Installation Guide for Windows