Nikon LS-10 Installation Guide for Windows - Manual (Page 3)

FCC Radio Frequency Interference Statement for Coolscan
This equipment has been tested and found to comply with the limits for a class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reason­
able protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communica­
tions. However, there is no guarantee that interference will not occur in a particular instal­
lation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
4. Consult the dealer or an experienced radio/TV technician for help.
Installation Safety Regulation of Coolscan Internal Model
This scanner has been approved by the Underwriters Laboratories, Inc., in the U.S., the
Canadian Standards Association, and as a class B device under Part 15 of the FCC
(Federal Communications Commission) Rules. This unit should only be installed in
equipment that has been approved according to the same standards.
AC line Cord
Note that different power cords are needed for different line voltage. If the line voltage is
greater than 125V AC, the plug should be rated for 250V AC and 15A (NEMA 6P-15),
this cord insulation should be at least STV type, and the gauge of the cord should be at
least AWG 18. If the line voltage is 125V AC or less, the plug should be rated for 125V
AC and lOA with SVT type resistance for the cord insulation and a gauge of at least AWG
18, and the cord should meet the safety standards of the country where the unit is used.
When Taking this Product Out of the Country
The use of this product may violate local laws and restrictions in some countries. If this is the
case, Nikon cannot bear any responsibility for any violations resulting from the use of this
product. Note that, in some countries, this product can be made to conform with regula­
tions through an internal adjustment. Therefore, before taking this product out of the
country, consult with your Nikon service representative.
Page II
Nikon Coolscan Installation Guide for Windows