Nikon LS-10 Installation Guide for Windows - Manual (Page 19)

Setting Up Coolscan Chapter 2
4. Never disassemble the scanner. It is very dangerous to touch the devices inside
the unit due to high voltages, and there are no user serviceable parts inside. Such
action may be a violation of your Nikon Limited Warranty, and would render the
warranty null and void.
General Safety Precautions
Always power off Coolscan and/or remove the power cord from the AC
source when any one of the following occurs:
1. The AC power cord (LS-lOE only) or 4-pin DC power plug (LS-10 only)
becomes damaged.
2. Any liquids are spilled into the scanner.
3. The scanner is exposed to excessive moisture.
4. The housing of the scanner has become damaged (LS-lOE only).
5. The housing is opened (LS-lOE only).
6. You suspect the scanner is not functioning properly.
7. If something unusual occurs, such as abnormal noise, odor, or smoke. In this
case, bring your Coolscan to the dealer where it was purchased or to an authorized
Nikon repair facility.
8. Do not attempt to insert slide mounts into Coolscan that are over 3mm thick.
Remount the film into an appropriate holder.
9. Do not attempt to insert slide mounts into Coolscan that are not flat. Remount
the film into an appropriate holder.
10. Do not force a slide or the film strip holder into the Coolscan film slot. A
smooth gliding action should be used during both insertion and removal.
11. Do not attempt to remove or reposition the slide or film strip holder in the
Coolscan film slot during the scanning process.
Page 12
Nikon Coolscan Installation Guide for Windows